Today I went on with my new design. As planned at home I had the battery PAC on the top, motor at the bottom as with the switch. I had To pik off the hot glue from my previous design and trim the plastic and metal a bit to ensure it fitted. However I have too much room at the front of the vehicle so I will have to try and sand as much if that off because everything else is already on.
Before we started today, Mr ward talked us through his design and a really good way to present your design on the assignment sheet. It was really good to see that his design was similar for what I had planned to do. But things for me to remember to add are, liberation between points, sand the wheels, and add some sort of air resistance illimantor to the front so that the air does by push to far back on the vehicle.
No comments:
Post a Comment